Random good picture Not show

1. Another area of expertise is the repair of combustion chambers, used in both aviation and industrial gas turbines.

2. Those huge combustion chambers mean it's a challenge making the fuel burn efficiently.

3. The underside forms the combustion chamber with the top of the piston.

4. The burner maintains the necessary temperature in primary combustion chamber when burning waste with low or zero heating value .

5. The combustion chamber is equipped with auxiliary boiler for adapting to the change of medical waste calorific value and assuring burning temperature and effect.

6. The remainder of the air-fuel charge in the combustion chamber can consist solely of fresh and residual gases, without unburned fuel.

7. The uniquely designed combustion chamber, enlarged cylinder working capacity, and excellent fuel consumption rate have contributed to a larger power output of GM series compared with OHV motors .

8. A combustion chamber and its igniters, injectors, and other related apparatus in jet engine or turbine.

9. The geometry of the combustion chamber and the atomisation of the fuel play a decisive role here.

10. Combustion chamber, exhauster, chimney on production workshop, safe environmental protection, external does not affect the workshop health.

11. The supersonic combustion chamber inlet is a 2 D convergent - divergent nozzle.

12. The effect of combustion chamber shape on the mixing process of an impinging gas jet is studied.

13. The condensed phase particle size distribution affects the combustion chamber and nozzle efficiency of solid rocket motors to some extent.

14. Usually a gas cooler is used between the combustion chamber and hydrator.

15. Using a ball end mill to form part of the combustion chamber.

16. The spark ignited direct injection fuel system may include a fuel injector that provides a fuel flow to the combustion chamber during the intake stroke.

17. The results show that the flame height and the excess air ratios depend on the system pressure drop but not on the absolute pressure at the combustion chamber.

18. The piston and the cylinder bore may partially define a combustion chamber.

19. If coal gas excess, it shown dark red, muddiness , and the wall of combustion chamber could be seen hardly.

20. Through the analysis of fuel spay instantaneous momentum and carbon laydown in combustion chamber, the reason that the shape of needle tip influence on engine performance has been illustrated.

21. By means of analysis on ignition fail reason of auxiliary combustion chamber for catalytic cracking unit, the unreasonable place existed in igniter was found, and improvement plan was given.

22. The process of pressure oscillation propagation from pipe-line to combustion chamber was theoretically researched in this paper; the transfer function was also deduced.

23. To seal rings the film needs adhesion and cohesion strength to prevent blow-by , compression loss, and oil by- passing the rings to the combustion chamber.

24. Through homogeneous mixing between gas and air in cyclical combustion chamber of gas external combustion type lime kiln, it can be enough combustion, has homogeneous flame temperature.sentencedict.com

25. Discharged from the air preheater hot air is divided into two units: a go Coal drying and conveying of pulverized coal, and the other shares directly into the combustion chamber .

26. An internal-combustion engine consisting essentially of an air compressor, a combustion chamber, and a turbine wheel that is turned by the expanding products of combustion.

27. The research results show that the engine combustion noise can be reduced by reducing the combustion pressure oscillation in combustion chamber.

28. The thermal post-combustion is used for two oven chambers, one of which operates in a pyrolysis or carbonisation mode and the other operates in the form of a combustion chamber.

29. It can be a effective way to be offered to optimize the matching of combustion chamber with injection nozzle for direct injection engine. It is of importance to the improvement of ...

30. These factors are mixture concentration, ignition advance angle, engine speed, temperature of cooling water and carbon deposit on the SUrfaces of the combustion chamber, etc.